IPEX4 MHF4 to Bare Solder Wire End Strip Tinned RF Cable

These 2 models of short length of flexible antenna cable, allowing them to be connected to IPEX4 connection, at a right angle. It is suitable as a replacement RF antenna for many NGFF interface Wireless card, such as Intel AX200NGW, 9260NGW, 7260NGW, 7265NGW, 8260NGW, 8265NGW, some Broadcom NGFF wifi card, Atheros Wireless adapter, Router LTE modem and etc... which is with the Ipex 4 or MHF4 connection.

Here are 2 types of cables, one is with SMA jack and another one is with RP-SMA jack connector. One of them will fit to your device.

Features:

• Brand by Akiba-Accessories
• SMA / RP-SMA jack to IPEX4 / MHF4 cable 
• Gold Plated Connectors
• Frequency up to 6GHz
• Terminated with 0.81mm coax cable. 
• Characteristic Impedance: 50 ohm
• 2 models for selection :
• Model 1) Connection End A : IPEX 4, Connection End B : SMA Female Hole - Outer Thread 
• Model 2) Connection End A : IPEX 4, Connection End B : RP-SMA Female Needle - Outer Thread
• Approx. Length : 0.3m 
• Color: Black.

Package Content:

• 1 x RP SMA Connector to Ipex 4 Thread Female Wire Cord

(Note 1 : Photo attached is for reference only, it may be slightly varied in items of colour, shape from the actual item delivered from time to time

Note 2 : There are 2 different types for selection, one is with needle pin and one is with hole. Please check carefully before on photo 2

Note 3 : This model is with IPEX Generation 4 connection. See photo 3 for the difference between normal IPEX vs IPEX4. If you are looking for a sligthly bigger size IPEX Generation 1, please see HERE)